The US House voted Tuesday to pass a measure to enact year-round Daylight Saving Time across the country, springing Congress forward into an issue that has long stumped lawmakers and spurred impassioned pleas by parents, farmers and others with sharply divergent views.
It will now head to the Senate for approval before going to the president for his signature — though its chances in the upper chamber remain unclear.
I doubt I will see the change either. I will say if you look around you can get dual use measuring devises. I got a great tape measure that is SAE and Metric. And digital calipers are already set up for it.
Tool wise it sucks having to have 2 sets… Especially having to have a metric and SAE adjustable wrenches (spanners for you over the pond).
The worst is getting out in the field with your 5lb hammer only to find you only brought metric stakes, so you gotta go all the way back and get your 3kg hammer.
Oh its the absolute worst! Or another pain, I have a cable 2 meters short and I left the cable stretcher at the shop!!! What do you do?
If you remembered your junction box pullers you can just scootch 'em a little closer. Just make sure you have a metric puller otherwise it’ll only pull 'em 2 yards and still be a little short.
Otherwise you gotta send the kid back to the shop to look for it.
My cables were RF so we didn’t use junction boxes so that tool was out unfortunately. Boy I wish we could have used it though!
Another hurdle was getting the signal up/down from the antenna(s). It never failed we didnt have enough frequency grease to get the job done. Many of junior helpers I sent out looking for that. Very kind of the other departments to help them on their adventure finding it. FacOps guys were the most helpful. And we help their apprentices find that Junction Box Puller, Cable Stretcher, etc.
Shit we had one kid nearly in tears looking for FG…
I just have two measuring tapes. With the dual tapes the markings are on the least convenient side of the tape half the time.
I do rough measurements in SAE so I know what to get at the lumber store, then do the actual cutting measured in metric. Those measurements happen at different times at different accuracy, and do not benefit from being on the same tape measure.
… Adjustable wrenches, you say?
Yes