Hi folks. I obtained a pre-owned Anycubic Vyper. Alas, every print features defects in the surface as shown in the picture. It occurs in any type of material. Does anybody know the source of this type of defects?
Hi folks. I obtained a pre-owned Anycubic Vyper. Alas, every print features defects in the surface as shown in the picture. It occurs in any type of material. Does anybody know the source of this type of defects?
That is true. That is why I bought that filament drying chamber. I’ll keep an eye on that.
Did you listen to it print? If it’s really wet sometimes you can hear a cracking sound as the moisture boils off. It causes little steam pops, which also result in that scrappy surface finish.